A required part of this site couldn’t load. This may be due to a browser extension, network issues, or browser settings. Please check your connection, disable any ...

H)Care & Cleaning: Bushwacker fender flares are built to last; any detergent you use to wash your vehicle is sufficient to clean the flare. Do not use any harsh abrasive detergents.

A)Bushwacker only approves installing the flares according to these written instructions with the hardware provided. WARNING: Failure to install according to these instructions will invalidate the …

FRONT MAIN & REAR FLARE ONLY: Place a Nut (NU1-0019) over the end of each Bolt and tighten, using a 1/2” wrench for the Nut and the supplied Torx Bit (SW1-0052) for the Bolt. Repeat for …

STEP 2 - EDGE TRIM INSTALLATION Peel two to three inches of red vinyl backing away from Edge Trim (GP1-0007) tape. Applying the adhesive side of the edge trim to the inner side of the fl are, affi …

Care & Cleaning: Bushwacker fender fl ares are built to last; any detergent you use to wash your vehicle is suffi cient to clean the fl are. Do not use any harsh abrasive detergents.

Pocket Hardware Installation Procedures: Put a Washer (WA1-0012) on each Bolt (SW1-0067).

Rear Flare Installation Procedures (Driver’s Side): Holding fl are in position on fender, use a grease pencil to mark six hole locations.

Front Flare Installation Procedures (Passenger’s Side): Remove fi ve factory screws with a 7/32” socket wrench. Remove two rear most factory screws with 9/32” socket wrench. Save screws for reinstallation.